Turquoise Design Co.
GOOD Armorer’s Gas Block
*GOOD Gas Blocks are not designed to be a drop in solution and are designed for Armorer’s use - may require honing & tap fitting for proper installation
GOOD Gas Blocks are Armorer-Fit Gas Blocks designed for maximum gas seal, ease-of-fitting and compatibility with all handguard and barrel combinations. Designed by an Armorer for Armorers to help build more reliable platforms for private and professional end users. Available in .625 & .750 Sizes.
GOOD Gas Blocks are made from Heat-Treated 4150 with a Manganese Phosphate Finish. The 4150 construction increases strength over more common materials typically used on gas blocks and helps to keep expansion rates of materials consistent especially with using 4150CMV barrels. Both bores are strictly regulated during both the machining and finishing processes with the primary bore being matched to the low end of the adjacent barrel journal spec, requiring each gas block to be fit for an unparalleled seal, even on “undersized” barrel journals.
The GOOD Gas Blocks also feature a pair of cross-pinning flats that allow the armorer to choose where to pin the barrel based on need or preference with the included 1/8” pins. The GOOD Gas Blocks also feature a smaller diameter hole on the front of the blocks, a design feature pioneered by the late Will Larson and brought to production by Roger Wang of Forward Controls Design with their GBF Gas Blocks that allows you to remove a seized gas tube with a 3/32” punch.
What’s Included
1x GOOD Gas Block
1x Gas Tube Pin
2x 10-32x1/8” Set Screws
1x 1/8” Coil Pin
1x 1/8” Solid Pin
Specifications
Shop other Gas Blocks & Gas Tubes
[ITEMPRICE]