Rearden R2S Flash Hider
The R2S from Rearden is a Closed-Tine A1 Style Flash Hider that also serves as a suppressor mount compatible with Rearden Atlas, Atlas XL and Atlas Helios QD and Plan B Suppressor Mounts.
About the Devices
Rearden muzzle devices feature the Atlas/Plan B suppressor mounting system that utilizes a combination of a taper and external threads. This system provides a repeatable and reliable suppressor mount that doesn’t add unnecessary weight, weight, or potential failure points with mechanical locks and latches.
Features
Flash Hider
The R2S is a Closed-Tine Flash Hider that uses 360 degree ports to mitigate flash signature.
Rearden Atlas & Plan B Compatible Suppressor Mount
All Rearden muzzle devices are compatible with the Rearden Atlas, Atlas XL, Atlas Helios QD and Plan B Suppressor Mounts.
Finish Options
Rearden Muzzle devices and Atlas’ are available in both a Heat Treat (gold) and a Nitride finish (black). The Nitride finish does lend itself to a tighter seal. Finishes on the muzzle device and adapter do not have to match (i.e. you can use a heat treat muzzle device with a nitride Atlas, etc. It will all still function)
Wrench Flats
Rearden muzzle devices are equipped with rear mounted wrench flats, allowing you to properly torque your muzzle device during installation and remove it should it ever get stuck or carbon locked.
What’s Included
1x Rearden R2S Muzzle Device
Specifications
17-4 PH
Atlas, Atlas XL, Atlas Helios QD Compatible
Plan B Compatible
Bore Size: All R2S variants regardless of thread pitch have a .40 bore
1/2x28: 2.05oz, 1.74" OAL
5/8x24: 1.6oz, 1.74" OAL
Available in H900 Wheat Finish or Black Nitride (67HRC Surface Hardness)
Shims Not Included
Installation
Ensure Firearm is unloaded
Clean Surfaces of Debris
Test Fit Muzzle Device/shims for proper alignment
Apply a small amount of Rocskett
Install and Torque Muzzle Device to approximately 30ft/lb
Make sure muzzle device is square against shoulder of barrel and check alignment before use
FAQ
Q: What size wrench do I need to install the Rearden R2S?
The Rearden R2S and all Rearden Muzzle Devices are equipped with 13/16” wrench flats. Although this sizing is not common along most muzzle devices/armorer's wrenches, a simple 13/16” crowfoot wrench can be purchased online for cheap.
Q: Is the R2S long enough to Pin and Weld?
While almost any muzzle device can be pinned and welded, these “short” Rearden devices would require a barrel length of ~15.1” to comfortably bring this device over over the 16” that most folks are aiming to achieve with a pinned and welded muzzle device. The “long” rearden muzzle devices such as the R2C and R2 will bring a 14.5” barrel over 16” when pinned and welded.
*Use on Q Cans will void your warranty
*Please Note all Rearden Muzzle Devices available at Revival Defense are standard Square Shoulder unless specified otherwise. If you are looking for a very specific variation such as 25 degree taper or Face mount, they are available directly from Rearden
Shop other Plan B Compatible Muzzle Devices