Rearden DPB Muzzle Brake
The DPB from Rearden is a long, dual port muzzle brake that also serves as a suppressor mount compatible with Rearden Atlas, Atlas XL and Atlas Helios QD and Plan B Suppressor Mounts.
About the Devices
Rearden muzzle devices feature the Atlas/Plan B suppressor mounting system that utilizes a combination of a taper and external threads. This system provides a repeatable and reliable suppressor mount that doesn’t add unnecessary weight, weight, or potential failure points with mechanical locks and latches.
Features
Muzzle Brake
The SPB is a single chamber muzzle brake that reduces felt recoil and also serves as a sacrificial blast baffle inside of suppressors.
Rearden Atlas & Plan B Compatible Suppressor Mount
All Rearden muzzle devices are compatible with the Rearden Atlas, Atlas XL, Atlas Helios QD and Plan B Suppressor Mounts.
Finish Options
Rearden Muzzle devices and Atlas’ are available in both a Heat Treat (gold) and a Nitride finish (black). The Nitride finish does lend itself to a tighter seal. Finishes on the muzzle device and adapter do not have to match (i.e. you can use a heat treat muzzle device with a nitride Atlas, etc. It will all still function)
Wrench Flats
Rearden muzzle devices are equipped with rear mounted wrench flats, allowing you to properly torque your muzzle device during installation and remove it should it ever get stuck or carbon locked.
What’s Included
1x Rearden DPB Muzzle Device
Specifications
17-4 PH
Atlas, Atlas XL, Atlas Helios QD Compatible
Plan B Compatible
1/2x28: .280 Bore, 2.65oz, 2.3" OAL
5/8x24: .40 Bore, 2.15oz, 2.3" OAL
Available in H900 Wheat Finish or Black Nitride (67HRC Surface Hardness)
Shims Included
Installation
Ensure Firearm is unloaded
Clean Surfaces of Debris
Test Fit Muzzle Device
Apply a small amount of Rocskett
Install and Torque Muzzle Device to approximately 30ft/lb
Make sure muzzle device is square against shoulder of barrel and check alignment before use
FAQ
Q: What size wrench do I need to install the Rearden DPB?
The Rearden DPB and all Rearden Muzzle Devices are equipped with 13/16” wrench flats. Although this sizing is not common along most muzzle devices/armorer's wrenches, a simple 13/16” crowfoot wrench can be purchased online for cheap.
Q: Is the DPB long enough to Pin and Weld?
Yes. The DPB will bring a 14.5” barrel over the 16” length when pinned and welded
*Use on Q Cans will void your warranty
*Please Note all Rearden Muzzle Devices available at Revival Defense are standard Square Shoulder unless specified otherwise. If you are looking for a very specific variation such as 25 degree taper or Face mount, they are available directly from Rearden
Shop other Plan B Compatible Muzzle Devices
[ITEMPRICE]