FORWARD CONTROLS DESIGN
EMR-HC Magazine Release Button
The EMR-HC has a slightly curved button surface shaped to the natural curvature of your finger. That curve, combined with the texture across the face, creates a self centering surface that resists the finger sliding vertically off the button.
Available with either the AA dimpled surface, which gives equal traction from any angle of approach, or continuous horizontal serrations. The texture runs uninterrupted across the full face on both. The taller profile makes it easier to press, sitting 0.04 inches above the factory magazine release button.
Machined from 4140 bar stock and QPQ coated.
Which One Do You Need?
The EMR-HC is recommended for 7.62 and .308 ARs. On those receivers its taller profile does not protrude above the mag release fence, and it lets you run AR-15 and M16 spec mag catches and ambidextrous mag catch releases.
On most forged 5.56 receivers the EMR-HC protrudes 0.08 inches above the mag release fence. Only 0.06 to 0.07 inches of travel is needed to drop a magazine, so it will work, but for a defense or duty 5.56 AR the EMR-H is the better choice at 0.01 inches of protrusion.
What's Included
1x Forward Controls Design EMR-HC Magazine Release Button in your selected surface
Specifications
- Machined 4140 bar stock, QPQ coated
- Curved, self centering button face
- Available in AA dimpled or continuous serrated surface
- 0.04 inches taller than the factory button
- 0.08 inch protrusion above the fence on most forged 5.56 receivers
- No protrusion above the fence on .308 receivers
- Recommended for 7.62 and .308 ARs
- Allows AR-15 and M16 spec mag catches on .308 builds
- Made in USA
Shop other Forward Controls Design Products
[ITEMPRICE]